KN-4059 GC for PCBs in Insulating Liquids

KN-4059 GC for PCBs in Insulating Liquids conforms to ASTM D4059 Standard Test Method for Analysis of Polychlorinated Biphenyls in Insulating Liquids by Gas Chromatography. This test method describes a quantitative determination of the concentration of polychlorinated biphenyls (PCBs) in electrical insulating liquids by gas chromatography. It also applies to the determination of PCB present in mixtures known as askarels, used as electrical insulating liquids.

KN-659 Autoignition Temperature Tester

KN-659 Autoignition Temperature Tester conforms to ASTM E659 Standard Test Method for Autoignition Temperature of Chemicals. A small, metered sample of the product to be tested is inserted into a uniformly heated 500ml glass flask containing air at a predetermined temperature. The contents of the flask are observe in a dark room for 10min following insertion of the sample, or until autoignition occurs. Autoignition is evidenced by the sudden appearance of a flame inside the flask and by a sharp

KN-1287 PH Meter

KN-1287 PH Meter conforms to ASTM D1287 Standard Test Method for pH of Engine Coolants and Antirusts and ASTM D1121 Standard Test Method for Reserve Alkalinity of Engine Coolants and Antirusts. pH is a measure of the hydrogen ion concentration and indicates whether an engine coolant, or a solution of these compounds is acidic, alkaline, or neutral. The pH range includes values from 0 to 14. Values from 0 to 7 represent the acidic half of the scale. Values from 7 to 14 represent the alkaline or b

KN-6617 Ageing Characteristics Tester

KN-6617 Ageing Characteristics Tester conforms to ISO 6617 Petroleum-based lubricating oils – Ageing characteristics – Determination of change in Conradson carbon residue after oxidation. This tester is able for determining the ageing characteristics of petroleum-based lubricating oils. It is applicable to those oils which have an evaporation loss of less than 15% mass fraction.

Analytical Balance

KN-6201 Intake Valve Deposit Tester (IDV)

KN-6201 Intake Valve Deposit Tester (IDV) conforms to ASTM D6201 Standard Test Method for Dynamometer Evaluation of Unleaded Spark-Ignition Engine Fuel for Intake Valve Deposit Formation. This test method covers an engine dynamometer test procedure for evaluation of intake valve deposit formation of unleaded spark-ignition engine fuels. This test method uses a Ford Ranger 2.3L four-cylinder engine. This test method includes detailed information regarding the procedure, hardware, and operations.